qbbr-make-code-grabber-1

qbbr-make-code-grabber-2

need

pinout JTAG interface to keychain

qbbr-make-code-grabber-3 qbbr-make-code-grabber-5

qbbr-make-code-grabber-4

  • keychain - 6pins interface
  • JTAG - 20pin interface
keychain PINs JTAG PINs
1 GND 18, 20
2 VCC 1
3 RESET 15
4 CLK/TCK 9
5 DIO/TMS 7
6 SWO/TDO 13

flashing device

!!! do not forget take out the battery from keychain.

  1. connect keychain to programmer
  2. connect SEGGER programmer to PC and wait to initialise device/driver
  3. connect mini-USB on keychain and wait (red led must is on), hold button 1 on keychain (for shutdown) and wait for PC initialise (beep new device)
  4. start JFLASH soft, set cpu is EFM32LG995F256 (32 bit / 48 Mhz) and SWD speed to 4000
    1. unlock chip
    2. erase chip
    3. flash .bin firmware
    4. lock chip
  5. prank gone right xD

enjoy

qbbr-make-code-grabber-6

only just for fun ^_^